Here's everything you need to do for a hot shower in your Cozy Cottage:
- For hot water, the water heater needs to be turned on. We need Propane gas for this.
- Open the gas cylinder and press the black button on the valve if necessary.
- Then also open the safety lever for hot water (on the right). This is located in the top kitchen drawer:
- Use the on-board display to check whether you have enough fresh water in the water tank. For an extensive shower, we recommend a fill level of 50%.
- The boiler must be filled with water. To do this, switch on the water pump on the on-board display, let the water run briefly and turn the tap to hot:
- Dann geh zum Truma-Display über der Schiebetür und befolge diese Schritte:
- To activate the screen, press the black button briefly.
- Turn the black button clockwise until you see the symbol with a thermometer under water blinking:
- Click on the black button to confirm.
- The text "OFF" will appear. Turn the wheel clockwise to select select the mode: ECO (40℃), HOT (60℃) or BOOST.
- Once you find the desired mode, press the button to select.
- The main menu will appear again and the boiler should be working.
- Wait about 20 minutes until the water in the boiler is hot.
- Turn the toilet into a shower by folding down the wall with the washbasin above the toilet. Turn the tap all the way to the left.
- Press the plastic clip next to the mirror to unlock the mirror wall:
- Then fold down the small magnetic glass door and attach it magnetically. No wooden part of the mirror wall should be visible:
- To shower, pull out the end of the tap, which acts as a shower head with a long hose, and attach it to the shower rail:
After showering, carefully push the hose back in and turn the tap to the left to swivel the mirror wall back into position - without damaging the tap.
Watch it in the video:
-Video to follow-
Troubleshooting
If there is a fault or the water does not heat up, try the following:
- Check whether gas is generally flowing.
- Make sure that the stopcock for the boiler (see above) is open.
- If you have forgotten to open the gas cylinder or the stopcock on the on-board display before switching on, this error must be deleted on the Truma control unit:
Common errors on the Truma display:
E517H // E507H // E516H: The error code appears when the gas supply is interrupted. Turn off the system, turn on the gas, press the black button to confirm that the error has been acknowledged. You may need to reset the appliance and start the process again.
W412H: The error appears when a window is open. This activates the safety pin to prevent exhaust gases from the heater entering the vehicle interior. To allow the exhaust gases to flow again, close the window.
W418H // W411H // W303H // E654H // E566H: The error code appears if the voltage of the camping battery is insufficient.
Check the battery capacity on your on-board display. If the value is below 12.3 V (50%), the battery must be charged before starting the heater.
Repeated unsuccessful restarts of the Truma unit can cause the heater to block.
If another error code is displayed, please contact us so that we can help you further.
Reset:
You found the cause of the error and fixed it? Great! Some errors disappear by themselves.
Others need to be confirmed by navigating to the black button to the exclamation mark (by turning the black button):
Now press the black button to confirm the error. The symbol should now disappear and the heater can be put back into operation using the familiar steps.
Resetting the Truma unit after an error/warning message. Only ONCE!!!
In some cases, it helps to manually reset the Truma. Try this only once – if you repeatedly reset it without eliminating the cause, the entire system can be permanently disabled.