🚿 Warm water and shower - Couple Cottage (Weinsberg CaraTour/CaraBus 600)

For a warm shower in the Couple Cottage, follow these steps:

• Turn on the camper unit and check the water level. For a longer shower, we recommend at least 50%:
  
• Switch on the water pump via the camper unit.
  
• The boiler and heating are controlled via the Truma unit. The Truma system runs on diesel. The tank must be at least 1/3 full.
• The boiler must be filled with water. To do this, set the tap to “hot” and let the water run briefly (about 2 minutes). Turn on the boiler using these steps on the Truma display:
  • Switch on the Truma device with the home button.
  • Press on “Hot water”:
    
  • Press “Turn on”:
    
  • Select the desired water temperature with the “+” and “–” buttons:
    
  • Let the water heat up for 20 minutes and enjoy.
  • Switch off the hot water on the Truma after use:
    

Note: The boiler works independently of the auxiliary heater and consumes fuel, so make sure the diesel tank is filled.

• Carefully pull the hose out of the tap and attach it to the shower holder.

  

• Always spread the shower curtain completely – otherwise water may damage the bathroom. The curtain is attached to the ceiling with buttons:
  
  Let it dry completely before storing it away.
• After showering, carefully push the shower hose back into the tap.

Click here to go directly to the instruction video:

- Video coming soon -

Outdoor Shower

For a warm shower in the Couple Cottage, follow these steps:

• Turn on the camper unit and check the water level. For a longer shower, we recommend at least 50%:
  
• Switch on the water pump via the camper unit.
  
• The boiler and heating are controlled via the Truma unit. The Truma system runs on gas. Open the gas valves shown here:
• Open the gas bottle (11 kg) in the left compartment of the trunk. Turn the brass regulator to turn on or off.
• Press and hold the black button for approx. 5 seconds:
  
• Also set the grey safety lever (heating symbol) in the kitchen to horizontal. It is located in the drawer under the rear bench seat:
  
  
• The boiler must be filled with water. Set the tap to “hot” and let the water run briefly (about 2 minutes). Turn on the boiler using these steps on the Truma display:
• Switch on the Truma device with the home button.
• Press on “Hot water”:
  
• Press “Turn on”:
  
• Select the desired water temperature with the “+” and “–” buttons:
  
• Let the water heat up for 20 minutes and enjoy.
• Switch off the hot water on the Truma after use:
  

• Carefully pull the hose out of the tap and attach it to the shower holder.

  

• Always spread the shower curtain completely – otherwise water may damage the bathroom. The curtain is attached to the ceiling with buttons:
  
  Let it dry completely before storing it away.
• After showering, carefully push the shower hose back into the tap.

Outdoor Shower

• The shower hose is located in the trunk compartment on the passenger side.
• Open the marked plastic cover and connect the shower hose there:
  
• Flip the small black lever to activate the water pump: